Description

DIY Rabbit Ear/Pullback handlebar 1″

Looking for a rabbit ear or pullback handlebar but can’t find the one that fulfills your imagination?

Look no further, we’ve got a set of pre bend tubes for you so you can create your own set of pullbacks.

Tubes have a 1″ outside diameter and a 2mm wall thickness.

Straight sides are approx 35 and 30cm and the bent is 100 degrees.

Just add a custom piece to connect the two pipes and two bungs to connect to your triple tree.

Sold in a set of  2 tubes.

These sets are produced inhouse at RJC-Choppers.

Check out all our other RJC -Chopper products that we create inhouse, found somewhere on the internet or purchased from small suppliers HERE!!

Can not find the correct parts? Contact us through the contact page so we can find the right part for you or check all the online catalogs on the bottom of the homepage

RJC-Choppers, Quality over Quantity